10
V 05/14
HOW TO USE THE FAN HEATER
Position the unit on a flat, stable surface.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
When you move the appliance, use the handle.
On/off button (on the rear, below the intake grille)
Bring the on/off button to the “I” position. When the appliance emits a beep this means that the fan heater is ready for use.
Bring the button to the “0” position to switch off the fan heater.
.
LED DISPLAY AND CONTROL PANEL
WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.
WHEN YOU TURN THE APPLIANCE ON AGAIN, AFTER SWITCHING IT OFF BY MEANS OF THE
BUTTON ON/OFF AND REMOVING THE PLUG FROM THE SOCKET YOU HAVE TO RESET THE
DESIRED MODE (ECO/COMFORT) AND OSCILLATION FUNCTION (SWING).
The appliance is fitted with an anti tip-up device that prevents it from operating when it detects that the product is inclined.
Do not position the appliance on its side or upside down.
SWING button
When the unit is operating, touch the SWING
button to make the appliance oscillate
automatically, shifting the air flow from left to
right. The LED is switched on simultaneously.
Touch the SWING button once again to interrupt
the oscillation and switch off the LED.
ON/OFF button
Touching the ON/OFF button the
appliance will begin to operate.
Touching the button ON/OFF
once again the appliance will
switch off. To switch off the fan
heater completely, place the
on/off button in the “0” position.
ECO/COMFORT selection button
- ECO mode: 1200 W reduced power
to save energy
- COMFORT mode: maximum heating
power (2000W).
ECO is the default mode.
COMFORT MODE LED:
maximum heating power
(2000W)
ECO MODE LED:
1200 W reduced power to
save energy
TIMER button
When the appliance is operating, the operating time can
be set by touching this button: the timer display shows a
flashing 0 and the + and - buttons can be operated
to set the desired time, between 1 and 12 hours,
with each touch corresponding with 1 hour. The
display shows the set time: wait 5” for the setting to be
confirmed. The unit will switch off automatically at the
end of the programmed time.
After the timer has been set, touching the button once
again will allow you to set the temperature: the
display will show ambient temperature and, by
operating the + and - buttons, the desired temperature
can be set between 15 and 35°C. Once the desired
temperature has been set, wait 5” for the setting to be
confirmed. After 5” the display will show the ambient
temperature once again.
NOTE - The default temperature is 25°C.
Buttons + and -
Allow you to adjust the
temperature and timer settings of
the appliance.
SWING LED
ON/OFF LED
(4 páginas)
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais